Volie Binding Compatibility

This is the World Famous TelemarkTalk / TelemarkTips Forum, by far the most dynamic telemark and backcountry skiing discussion board on the world wide web. We have fun here, come on in and be a part of it.
Post Reply
User avatar
GLB
XCD Enthusiast
XCD Enthusiast
Posts: 80
Joined: Sat Aug 27, 2016 6:24 pm

Volie Binding Compatibility

Post by GLB » Sun Mar 26, 2017 6:50 pm

Anybody know if the Volie Hardwear rear assembly will fit the Volie 3pc toe piece ? Are they the same toe piece?

User avatar
LooseHeel
XCD Enthusiast
XCD Enthusiast
Posts: 37
Joined: Mon Mar 09, 2015 7:49 am

Re: Volie Binding Compatibility

Post by LooseHeel » Sun Mar 26, 2017 7:25 pm

They're not the same, but can be made to fit. The Hardwire rods are thicker than the cable ends. File the sides of the hardwire until they fit the 3pc toepiece.

User avatar
GLB
XCD Enthusiast
XCD Enthusiast
Posts: 80
Joined: Sat Aug 27, 2016 6:24 pm

Re: Volie Binding Compatibility

Post by GLB » Sun Mar 26, 2017 8:10 pm

Thanks. How much would I need to file?

User avatar
LooseHeel
XCD Enthusiast
XCD Enthusiast
Posts: 37
Joined: Mon Mar 09, 2015 7:49 am

Re: Voile Binding Compatibility

Post by LooseHeel » Mon Mar 27, 2017 7:41 am

Until it fits ;) Mine have approximately 1.0mm total filed away. 0.5mm each side. Takes only a few minutes. Strength of the hardwire won't be affected, there's still plenty of material.

Post Reply