Howdy all! Ran a search for this, but didn't find anything too useful...
Anyway, got a good deal on a pair of Rottefella NTN Freedom binders, and was hoping to mount 'em up myself. Found a paper template on the Rottefella site, but my printer won't print the A3 page size that the jig requires, so I'm kinda fishing around for some help/advice. I do have a jigarex, but I'd rather not lay out the $50 for the Freedom plates if I can avoid it.
I'm gonna mount them onto an old pair of Voile Chargers that previously had a G3 Onyx on 'em; hoping the hole conflict isn't too big a deal (guessing it won't be). Any and all advice on how best to go about locating a paper template is sure appreciated, as well as any other tidbits that might be helpful once I get down to it...Thank you so much!
