Remove plastic caps from Voile risers

[gitrinec]

I didn't Epoxy them in, the way I hammered them out with a small screw driver basically made a very small hole right under the top on the side, so I think they'll be ok I just popped them back in.

[anemic]

So, like me, you mounted the heel pads, AND THEN saw your climbing bails and realized these need to be mounted prior to screwing the heel pad to the ski?

[gitrinec]

Anemic, Nope, I was adjusting the heel pad location a bit before I screwed the screws all the way down and the back one popped out, I hate mounting those, they better be useful when skiing, lol I had to pop those out only on the front riser because somehow I didn't screw it flush enough with the ski, though I might have to have someone look at that before I use them. The screw holes should of been fine, but I'm wondering if the screws were too long.