This is the World Famous TelemarkTalk / TelemarkTips / Telemark Francais Forum, by far the most dynamic telemark and backcountry skiing discussion board on the world wide web since 1998. East, West, North, South, Canada, US or Europe, Backcountry or not.
This is the World Famous TelemarkTalk / TelemarkTips / Telemark Francais Forum, by far the most dynamic telemark and backcountry skiing discussion board on the world wide web since 1998. East, West, North, South, Canada, US or Europe, Backcountry or not.
This is the World Famous TelemarkTalk / TelemarkTips Forum, by far the most dynamic telemark and backcountry skiing discussion board on the world wide web. We have fun here, come on in and be a part of it.
Hi all
Yesterday I was checking my skis. Found out that the spring to my 7tm power binding was broken.
I have spent many hours on google looking for a place where I can buy a new one.
Does anybody here now a place that sells that spring anymore?
You might also try posting this on the "earn your turns" forum site as well (http://www.backcountrytalk.earnyourturn ... -amp-Grill). A lot of the old T-tips folks are there, and it seemed like this binding has a long history among many of the folks that frequent that list.
Hmmm - I don't think drilling the ID of a spring will work.
2 reasons. Spring is most likely hard - you'll ruin your drill bit trying. Also, most likely, the spring will break within a few cycles if you machine it, if there is some case, and your bit is hard enough to remove it, you'll reduce its fatigue strength, but likely if you do get through it, you'll just introduce a stress riser.
