Hi there folks,
I am need of a paper template for the telemark tech systems and was wondering if anyone had such laying around in form of a pdf document or such? It would be greatly appreciated.
adrian
TTS template
Re: TTS template
No one? Not even a link? I don't have the ski the binding was previously on so I cannot make a jig from that 
-
bogon
- Posts: 64
- Joined: Fri Dec 27, 2013 5:09 am
- Location: Eastern Alps, a.k.a Carpathians
- Occupation: Life
Re: TTS template
Post Your measures and I'll try to make one. I'll need toe pattern (have only Dynafit Vertical ST toe pattern ready with 30mm hole spacing IIRC), along with BSL, BoF location w.r.t. tech fittings, spring block and heel block pattern at minimum (that's if You know where to mount; if You don't - ski model, widest points from tail, and contact points from tail for cambered and decambered ski are needed, too).
I like all kinds of snow. The only poor snow I know of is ice. That better be climbed.
Re: TTS template
Hey bogon,
I can always mount it freehand and get it about right. I have access to a dynafit jig for the toepart so the rest should be fairly easy. But thanks for your offer! I am pretty good at mounting binding, but if someone had a paper jig or something they could have shared with me that would make my life easier.
Adrian
I can always mount it freehand and get it about right. I have access to a dynafit jig for the toepart so the rest should be fairly easy. But thanks for your offer! I am pretty good at mounting binding, but if someone had a paper jig or something they could have shared with me that would make my life easier.
Adrian