Remove plastic caps from Voile risers

[gitrinec]

Anyone ever have to remove those plastic screw covers on the Voile riser, how'd you remove them?

[MikeK]

I drill a hole in 'em, just a small one, then pull them out with a pick. You can seal the hole with a dab of JB Weld epoxy.

[gitrinec]

Was my afterthought, drill a hole, lol They make them hard to remove for sure.

[mainer]

I run a drywall screw into them and pull with vice grips.

[Woodserson]

Small sharp pick that comes in those screwdriver tool sets, just poke and pull. The 90 deg one works a little better. No drills, tiny hole. Easy.

[dorthman]

I use one of those eyeglass/precision screwdrivers. Flat head obvs. Can usually wiggle it in there and pop the caps out.

Drywall screw ain't a bad idea tho. I like that

[StormyMonday]

Just did that. I just screwed a small screw into the top and pulled it out by that. Put back in don't even notice the little holes

[gitrinec]

Thanks for all the recommendations, I ended up using a small screwdriver and hammered into the edge, small hole on the side but I'll epoxy it.

[Rodbelan]

Not sure about epoxy... if you need to pull them out again, might be difficult. Just a dab of shoegoo or equivalent. It seals and very easy to remove.

[MikeK]

Yeah, don't epoxy them in... I just recommended epoxy to repair the hole.