Page 1 of 1
Very important, urgent NNN binding question
Posted: Tue Mar 03, 2015 7:34 pm
by MikeK
Where do you mount for a balance between touring and turns? Does the NNN pivot become the new 'pin line'?
Re: Very important, urgent NNN binding question
Posted: Tue Mar 03, 2015 8:18 pm
by Woodserson
The NNN pin goes at the balance point for the ski. Adjust from there for personal preference. I have a paper jig I could try to scan for you.
Re: Very important, urgent NNN binding question
Posted: Tue Mar 03, 2015 8:21 pm
by bgregoire
I would not hesitate to go forward, up to chord center, if you are looking for better control on the down. The NNN pin line = 3 pin line by the book. In practice though, I wouldn't be surprised if the NNN pin line acts as if it is actually further back than the 3 pin line considering its placement on the boot. PS: I have an NNN BC binding pin on balance point on some Asnes Admunsen skis right now and am struggling with them anywhere other than the flats, I plan on moving them up 2 cm or so, chord center being 3-4 cm beyond balance point in this case.
Re: Very important, urgent NNN binding question
Posted: Tue Mar 03, 2015 8:29 pm
by MikeK
No need for the scan Woodserson - I'm going to have the shop do it because they have the jig and it's not all that expensive. Thanks anyway.
I was thinking of mounting my Eons at chord vs balance - the other two pairs of skinnier skis I have are mounted at balance.
I was thinking the same thing as well Ben... seems to me the NNN pivot is about a cm or so back from a pin line.