Page 1 of 1
Quiver Killers with Xplore
Posted: Wed Jan 10, 2024 12:02 pm
by Alexstrong
Has anyone mounted Xplore bindings with quiver killers?
Can’t find the screws listed on their site and trying to avoid doing the fit kit.
Any info on Screw head type and length would be appreciated
Re: Quiver Killers with Xplore
Posted: Wed Jan 10, 2024 2:20 pm
by Montana St Alum
I just ordered from "Binding Freedom". They have information to help with screw choice.
I've used both QK and BF and they both work about the same. They both take M5, 0.8mm screws (I believe - double check that) of different lengths, so screws are pretty easy to find, once you figure out overall length and head type.
https://www.bindingfreedom.com/convert- ... -and-faqs/
Edit: Actually, it looks like they have a screw listed as working.
Xplore
14 QTY 10mm low heads with 8mm reduced heads
https://www.bindingfreedom.com/rottefella/
Re: Quiver Killers with Xplore
Posted: Wed Jan 10, 2024 2:25 pm
by Alexstrong
Thanks, just went with binding freedom as well thanks to a rec, found the screw size in their list and ordered,
Re: Quiver Killers with Xplore
Posted: Thu Jan 11, 2024 1:50 pm
by Kneedle Drop
I used Binding Freedom inserts with my Xplore bindings. I had to grind the screw heads to get them to sit flush with the surface of the binding. Without modification I found I could not insert the flexors. I ground the heads using a drill press. It takes time, but it isn't difficult and the results were good.