Page 1 of 1
TTS template
Posted: Sun Jan 26, 2014 12:22 pm
by adrian
Hi there folks,
I am need of a paper template for the telemark tech systems and was wondering if anyone had such laying around in form of a pdf document or such? It would be greatly appreciated.
adrian
Re: TTS template
Posted: Thu Jan 30, 2014 3:51 am
by adrian
No one? Not even a link? I don't have the ski the binding was previously on so I cannot make a jig from that
Re: TTS template
Posted: Thu Jan 30, 2014 8:05 am
by bogon
Post Your measures and I'll try to make one. I'll need toe pattern (have only Dynafit Vertical ST toe pattern ready with 30mm hole spacing IIRC), along with BSL, BoF location w.r.t. tech fittings, spring block and heel block pattern at minimum (that's if You know where to mount; if You don't - ski model, widest points from tail, and contact points from tail for cambered and decambered ski are needed, too).
Re: TTS template
Posted: Fri Jan 31, 2014 4:16 am
by adrian
Hey bogon,
I can always mount it freehand and get it about right. I have access to a dynafit jig for the toepart so the rest should be fairly easy. But thanks for your offer! I am pretty good at mounting binding, but if someone had a paper jig or something they could have shared with me that would make my life easier.
Adrian